Adding Rear Weight; Installing Eu Decals; Product Overview; Controls - Toro 04520 Operator's Manual

8

Adding Rear Weight

Parts needed for this procedure:
Weight kit, 121–6665 (purchase separately) Note:
1 This kit is not required for units with the 3 wheel drive
kit installed.
Procedure
This unit complies with the ANSI B71.4-2004 and EN 836
Standards when equipped with weight kit 121–6665.
Note: If the unit is equipped with a three wheel drive kit
additional weight is not required to meet ANSI B71.4-2004
and EN 836 standards.
9

Installing EU Decals

Parts needed for this procedure:
1 Warning decal 117-9537
Procedure
If this machine will be used in the EU, affix the warning decal
117-9537 over English warning decal 117-9536.

Product Overview

4
2
3
1
g014674
1. Engine
2. Roll bar
3. Control panel
4. Seat

Controls

Traction Pedal
The traction pedal (Figure 15) has three functions: to make
the machine move forward, to move it backward, and to stop
the machine. Press the top of the pedal to move forward
and the bottom of the pedal to move backward or to assist
in stopping when moving forward. Also, allow the pedal
to move to the neutral position to stop the machine. For
operator comfort, do not rest the heel of your foot on reverse
when operating forward (Figure 16).
18
5
6
7
Figure 14
5. Steering wheel
6. Traction pedal
7. Foot rest
8. Reels with grass baskets
8