Toro 38365 Operator's Manual page 7

Converting from
Snowthrowing to Sweeping
Important: Disconnect the power from the Power
Shovel Plus before performing this procedure.
1. Use a 9/16-inch wrench to remove the bolt on the side
of the housing.
2. Remove the snowthrower rotor from the housing.
3. Install the broom in the housing.
4. Secure the broom with the bolt that you previously
removed.
5. Tighten the bolt on the side of the housing.
6. Install the deflector.
Note: The deflector snaps into place.
7. Loosen the lower knob on the shaft.
8. Rotate the handle grip to the opposite side of the shaft.
7