North american cab light kit for 2015 and after groundsmaster 360 4-wheel drive multi purpose machine and groundsmaster 3280 series cab (8 pages)
Summary of Contents for Toro 31952
Page 1
Form No. 3438-952 Rev A Slope Sensor Kit Groundsmaster ® 3200 or 3300 Series Traction Unit Model No. 31952 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger.
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. – No parts required Prepare the machine. Sensor module Bolt Mounting bracket Install the kit. Wire harness Alarm Plastic plug Cable tie Decal Install the decal.
Page 3
Remove and discard the plastic plugs securing the parking brake cover to the machine (Figure 2). Remove the parking brake cover. Note: Use a putty knife or a plastic-fastener removal tool when removing the plastic plugs. g317813 Figure 3 g307039 1.
Page 4
Installing the Alarm Remove the knockout from the panel behind the parking brake (Figure g307043 Figure 5 g307042 Figure 4 1. 90° connector 3. Second connector 1. Alarm 3. Plastic nut 2. Cable tie 2. Knockout Route the wire harness back and plug the Remove the plastic nut from the alarm and use second connector into the machine wire harness it to secure the alarm through the opening left by...
Page 5
Installing the Decal Calibrating the Sensor Install the decal on the machine as shown in While on a flat surface, remove the plug from Figure the calibration connectors (Figure g307046 g307045 Figure 7 1. Decal Install the front left tire, torque the lug nuts, and lower the machine.
Operation Using the Slope Sensor The light and alarm indicates the severity of the slope: • Green light—normal operating conditions • Slow, flashing red light and B2713 displaying on the screen—moderate slope • Fast, flashing red light, audible alarm, and B2714 displaying on the screen—steep slope;...