Toro 30410 Operator's Manual page 50

Figure 73
1. Test port B
Test Port C (Figure 74), located on the left side of
the machine, is used to measure the left cutting
unit pressure.
Figure 74
1. Test port C
Test Port D (Figure 75), located on the right side
of the machine, is used to measure the right cutting
unit pressure.
Figure 75
1. Test port D
Test Port E (Figure 76), located under the radiator,
is used to measure the four-wheel drive pressure
in reverse.
Figure 76
1. Test port E
Test Port F (Figure 77), located under the seat, is
used to measure the lift circuit pressure.
Test Port G (Figure 77), located under the seat, is
used to measure the charge circuit pressure.
Figure 77
1. Test port F
Test Port H (Figure 78) is used to measure the
front cutting unit circuit pressure.
Test Port J (Figure 78) is used to measure the
steering circuit pressure.
50
2. Test port G