Table of Contents
Advertisement
Glow Plug Indicator Light
When lit, the glow plug indicator light (Figure 2)
indicates that the glow plugs are on.
Engine Temperature Gauge
This gauge (Figure 2) indicates the engine coolant
temperature.
Speed Limiter
Adjust the screw (Figure 3) to limit the amount
the traction pedal can be depressed in the forward
direction to limit speed.
Important: The traction pedal must contact
the speed limiter before reaching the end of
the pump stroke to prevent pump damage.
Figure 3
1. Speed limiter
Lift Levers
The levers (Figure 4) raise and lower the cutting
units.
Cutting Unit Service Lock
The cutting unit service lock (Figure 4) locks the
front cutting unit lift lever when the cutting unit
is in the raised position.
Key Switch
The key switch (Figure 4) has three positions: Off,
On/Preheat, and Start.
PTO Switch
The PTO switch (Figure 4) has three positions: On
(engage), Neutral, and Off (disengage). Carefully
lift and push the PTO switch forward to the On
position to start the implement or cutting unit
blades. Slowly pull the switch backward to the Off
position to stop implement operation.
Hi-Lo Speed Control
The control (Figure 4) allows the speed range to
increase for transport of the machine.
Flow Divider Switch
Press and hold flow divider switch (Figure 4)
to enhance traction drive performance in
compromised operating conditions.
1. Lift lever
2. Front cutting unit service
lock
3. Key switch
4. PTO switch
5. Hi-lo speed control
6. Flow divider switch
7. Cruise control (optional)
Cruise Control (Optional)
The cruise control (Figure 4) sets the speed of the
machine.
Fuel Gauge
The fuel gauge (Figure 4) indicates the level of fuel
in the tank.
Hour Meter
The hour meter (Figure 4) shows the total hours
that the machine has been operated.
17
Figure 4
8. Alarm silence switch
9. Temperature reset switch
10. Hour meter
11. Fuel gauge
12. Throttle
13. Audible alarm
14. Power point
Advertisement
Table of Contents
