Table of Contents
Advertisement
* The components vary depending on the requirements of the roof, the structural analysis and the choice of
components and may deviate from the images above.
Work
Image
equipment
Cordless
screwdriver
Torque key
up to at least
12 Nm
Chopsaw
Place / replace
tool base trough
150-30
4.2 Installation system components – installation variants
Image
Tool
** Required components for ballast distribution at system edge, depending on substructure construction.
Use for tool
Bit Torx TX 40
Socket bit AF 8 mm
Socket bit AF 8 mm
---
For place / replace of base foot and
module supports set in the base
trough 150-30
Component**
Module support set 13° 150-30 e/w
Material: Aluminium
Support Brace 20x20x1,5 East West
Material: Aluminium
C-rail (base profile, base trough)
Material: Aluminium
Rail connector set
Material: Aluminium and V2A
Tool: Special lock nut AF 18 deep
5
Use
Component
connections, clamp
assembly
Clamp assembly
Cutting rails
Correct installation
Product group
Support and module
fastening
Support and module
fastening
Module support rail
Module support rail
Advertisement
Table of Contents
