Information - BayWa closed II Installation Manual

1 INFORMATION

Safety information
Installation work may only be carried out by qualified expert personnel. Safety clothing in accordance with
the relevant national regulations and guidelines must be worn during all work.
Installation must be carried out by at least two people so as to ensure that help is available in the event of
an accident.
All relevant nationally and locally valid occupational safety regulations, accident prevention regulations,
standards, construction regulations and environmental protection regulations must be observed, along with
all regulations of the institutions for statutory accident insurance and prevention.
National regulations for working at height or on roofs must be complied with.
Electrical work must be carried out in compliance with nationally and locally valid regulations and guidelines
and in accordance with the safety regulations for electrical work.
The earthing / potential equalization of the installation system must be carried out in line with the nationally
and locally valid standards and guidelines.
Classification into hazard classes
In order to draw the user's attention to potentially hazardous situations, the following hazard classes are
used, based on ANSI Z 535. The hazard class describes the risk in the event that the safety information is
not observed.
Warning symbol with signal word
General information
The product must be checked for completeness upon receipt using the accompanying delivery notice.
BayWa r.e. Solar Energy Systems GmbH shall assume no costs or guarantees for any subsequent
deliveries
by express delivery if missing material is only noticed during installation.
The installation system is suitable for securing PV modules with standard market dimensions.
The maximum permitted module width is 1.10 m.
The suitability of the installation system for the respective project must be checked on an individual basis
with respect to the existing roof sealing / roof construction.
The roof sealing / roof construction must meet the requirements of the installation system in terms of load-
bearing capacity, load-bearing structure and condition.
The user must test the load-bearing capacity of the existing roof / roof construction (concrete ceiling,
purlins, trapezoidal panels, etc.) or have this tested.
Hazard class as per ANSI Z 535
DANGER! indicates an immediate hazard. Failure to prevent
this could result in death or severe injury.
WARNING! indicates a potential hazard. Failure to prevent
this could result in death or severe injury.
CAUTION! indicates a potential hazard. Failure to prevent
this could result in slight or minor injury.
NOTICE! indicates a potentially damaging situation. Failure
to prevent this could result in damage to the system or
something in its environment.
1