3Com 4210 Release Notes page 40

Hide thumbs Also See for 4210:

Table of Contents

Switch 4210 V3.01.09 Release Notes

Note:

After the terminal baud rate is modified, it is necessary to disconnect and then re-connect the terminal

emulation program to validate the new setting.

Step5 Select [Transfer\Send File] from the terminal window. Click <Browse> in the pop-up window and

select the software to be downloaded. Change the protocol name to Xmodem.

Figure 2 Send File

Step1 Click <Send> and the system will display the window as shown Figure 2.

Figure 3 Xmodem File Send

Step1 After the downloading of the program is completed, the screen will display the following information:

Loading ........................................................done

Please input a new file name

Writing flash................................................done

Please input the file attribute (main/backup/none):main /specify the file attribute/

February 27, 2009

:switch.bin/specify the file name in flash/

Page 40 of 43

Table of Contents