3Com 4210 Release Notes page 33

Switch 4210 V3.01.09 Release Notes
LSOD06271
First found-in version: V3.01.03
Condition:
As the figure above, four ports of two switches connect across in pairs, STP enabled, LSW-A as STP
Root Bridge, then enables LACP on each port.
Description:
Four ports establish the aggregation group successfully, however the link between the port 2 of LSW-
A and the port 1 of LSW-B can not forward packets normally.
LSOD06263
First found-in version: V3.01.03
Condition:
Enable MAC-authentication, configure accounting-on under the radius scheme, save the configuration,
then restart the switch. During the starting, send MAC authentication packets to the switch.
Description:
The memory of device leaks.
LSOD06284
First found-in version: V3.01.03
Condition:
Enable Dot1x and configure the EAP authentication mode. Enable Dot1x re-authentication and
disable Dot1x hand-shake. The user passed the Dot1x authentication successfully.
Description:
After a long time, the user was cut off for the reason of Dot1x re-authentication failure.
LSOD06432
First found-in version: V3.01.03
Condition:
Enable Dot1x and configure the EAP authentication mode. After the user passed the Dot1x
authentication successfully, send the EAP response packet from the PC with the abnormal length
value in the data content.
Description:
February 27, 2009 Page 33 of 43