3Com 4210 Release Notes page 18

Switch 4210 V3.01.09 Release Notes
Version number Item Description
MAC address, VLAN ID, state of the MAC
address, port number and aging time.
Executing this command with count will display the
information about the number of multicast MAC
address entries added on the switch.
Example:
<4210>display mac-address multicast static vlan 1
Command 2
Syntax:
mac-address multicast mac-address interface
interface-list vlan vlan-id
undo mac-address multicast [ mac-address
[ interface interface-list ] vlan vlan-id ]
View: System view
Parameter:
mac-address: Multicast MAC address.
vlan-id: VLAN ID.
interface-list: Defines one or multiple forwarding
ports. You can provide up to 10 port lists, by each
of which you can specify an individual port in the
form of interface-type interface-number , or a port
range in the form of interface-type start-interface-
number to interface-type end-interface-number ,
where the end port number must be greater than
the start port number. Refer to the parameter
description in the "Port Basic Configuration" part in
this manual.
Description:
Use the mac-address multicast command to add a
multicast MAC address entry.
Use the undo mac-address multicast command to
remove a multicast MAC address entry.
Each multicast MAC address entry contains
multicast address, forward port, VLAN ID, and so
on.
Related command: display mac-address multicast
static.
Example:
[4210] mac-address multicast 0100-5e0a-0805
interface Ethernet 1/0/1 vlan 1
Command 3
Syntax:
mac-address multicast mac-address vlan
vlan-id
February 27, 2009 Page 18 of 43