Numark CDMIX1 Quick Start Manual page 6

USING THE BPM DISPLAY FEATURE
Press the BPM button to select the BPM feature on the display on the side of the CD player that you wish to set. Tap the Counter
button to the beat of the music.
You will see the BPM number appear in the display. The more times you tap the more accurate your number will be. When you
adjust the pitch slider the display number will change by an equal percentage.
BEAT MATCHING USING PITCH BEND
If you find the BPM's (Beats Per Minute or Tempos) are the same, however, the drum beats are not matched you will need to
temporarily change the pitch. The illustration below shows how to match the beat of PLAYER 2 to the beat of the music being
played on PLAYER 1. (This procedure can be done on either PLAYER).
After matching the BPM's adjust the pitch temporarily as follows:
When PLAYER 2 is rotate the jog wheel counter clockwise
The pitch changes automatically while the jog wheel is rotated. The faster you rotate the wheel the more you change. Releasing the
wheel results in a return to the original pitch. (So the BPM's are once again the same.)
EXAMPLE OF MIXING USING BOTH PLAYERS OF YOUR CD PLAYER
While playing a disc on PLAYER 1, load a disc into PLAYER 2 and select your next track, match its pitch to the track playing on
PLAYER1 and when you are ready use the crossfader on your mixer to fade from PLAYER 1 to PLAYER 2.
Load a disc in PLAYER 1 and
select the track and press PLAY.
Load a disc in PLAYER 2 and
select the track then play.
Set and edit a start cue point on
PLAYER 2
Check your new cue point
Do a MIX!
P LAYER 1
Loa d a dis c a nd pre s s the
OPEN/CLOS E button.
P LAYER 2
Loa d a dis c a nd pre s s the
OP EN/CLOS E button.
P LAYER 2
P re s s the P a us e button of P LAYER 2.
P LAYER 2
Lis te n with the monitor a nd
pre s s the pla y button.
P LAYER 2
With a ma tching downbe a t from
P la ye r 1 pre s s the pla y button.
When PLAYER 2 is behind rotate the jog wheel clockwise
P LAYER 1
S e le ct the tra ck to be pla yed.
P LAYER 2
S e le ct the tra ck to be pla yed.
P LAYER 2
Ra pidly s e a rch for a cue point us ing
the oute r whe e l
P LAYER 2
P re s s the cue button the n pla y to be
s ure of the s e t cue point.
P LAYER 2
If you a re be a t mixing, turn on your
P itch a djus t a nd follow the directions
for beat matching.
6
P LAYER 1
P re s s the P LAY button
P LAYER 2
P re s s the P LAY button
P LAYER 2
S lowly s e t the right cue point
us ing the inne r whe e l
P LAYER 2
Re s e t the pla ye r to the Cue point
by pre s sing Cue
MIXER
When you a re ha ppy with your mix
move the cros sfa de r a ccordingly.