Conversion Details - Real Flame PIT FIRE SERIES Installation & Operating Manual

CONVERSION DETAILS

Natural gas to propane.
1. Turn appliance off.
2. Turn gas supply off.
3. Disconnect gas from valve inlet connection.
4. Remove fire assembly from enclosure.
5. Unscrew pilot assembly from valve.
6. Remove ignition wires from pilot.
7. Unscrew valve assembly from burner and tray.
8. Unscrew and remove aeration - injector fitting.
9. Replace aeration – injector fitting with correct gas type. Ensure connections are tight with
no gas leaks.
10. Remove pilot assembly and replace with correct gas type.
11. Reattach valve assembly. Ensure connections are tight with no gas leaks.
12. Reattach pilot assembly tubes and wires.
13. Remove Natural gas regulator spring from valve.
14. Replace regulator spring with correct gas type spring.
15. Refit assembly to enclosure.
16. Connect gas to inlet connection.
17. Check for gas leaks.
18. Fill tray with rock media.
19. Start appliance and adjust burner pressure to correct pressure.
20. Remove manometer and tighten gas test point.
21. Check for gas leaks.
22. Turn appliance off.
21