LevelOne wap-0007 User Manual page 30

Service area name: Displays the name of the service area.
SSID: Displays the name of wireless network.
Type: Displays the application type.
Frequency band: Supports two frequency bands, 2.4 G / 5 G, in which ALL means that two frequency bands
of the service area will be distributed.
VLAN ID: Displays the VLAN value, which is between 1-4094.
Address pool: Displays the name of the address pool. For the details of setting the beginning and end address
of the address pool, please refer to the chapter:
6.2.2.4 System
In this interface, the working mode of AP, the way to obtain the IP address of AP and upgrading of the AP
software can be set.
The AP's working mode is divided into Fit AP and Fat AP. In the Fat AP mode, AC can manage the AP; in the
Fat AP mode, the AP can configure independently without AC management. It is recommended to restart your
device for the configuration to take effect if the device is to be switched in modes no matter which mode it works
under.
1) System settings
Figure 6- 10 Setting of service area
VLAN Settings.
Figure 6- 11 System settings
26