Cleanup - WAGNER motocoat Owner's Manual

Flushing the unit
Before you begin
When cleaning, reference the material manufacturer's guidelines to
determine the proper cleaning solution and process.
IMPORTanT: never clean air cap or air holes in the nozzle
with sharp metal objects. Do not use solvents or lubricants
containing silicone.
Special cleanup instructions for use with
flammable solvents:
• Always flush spray gun outside.
• Area must be free of flammable vapors.
• Cleaning area must be well-ventilated.
• Do not submerge turbine!
note: All materials need to be properly and completely cleaned
from both the gun and cup prior to using any new spray
materials.
1. Unplug the power cord. Loosen the material container by 1/2
turn, but do not remove it. This will relieve any pressure left
over in the system.
Pull the trigger so that the material inside the spray nozzle
drains back into the container.
2. Unscrew the container and remove. Empty any remaining
material back into the material container.
3. Pour a small amount of the appropriate cleaning solution into
the cup (Warm, soapy water=1/2 full. Mineral spirits=1/4 full).
4. Attach the cup to the nozzle and plug in the sprayer.
5. Spray the cleaning solution into a safe area.
While spraying, gently shake the spray gun. This slight
agitation will help break up smaller particles of spray material.
6. Unplug the power cord. Loosen the material container by 1/2
turn, but do not remove it. This will relieve any pressure left
over in the system.
Pull the trigger so that the material inside the spray nozzle
drains back into the container.
IMPORTanT: If you cleaned the sprayer using mineral
spirits, repeat steps 1-6 using warm, soapy water.
Move on to "Cleanup - Cleaning the nozzle", next page.
4
English
12

Cleanup

5
Empty waste
container
1
1/2
PULL
2
3
6
1/2
PULL
© Wagner Spray Tech - All Rights Reserved