Presetting Stations; Recalling A Preset Station - Sangean HD Radio HDT-20 User Manual

Presetting stations

There are 10 presets each for FM and AM radio. They are used the same way for each operating
mode.
1. Press the Standby/Power button to switch on your radio.
2. Tune to the required radio station as previously described.
3. To store the station as a preset, press and hold the Preset button and the display will show
"Preset Store".
4. Press and release the required preset number button. You will hear a beep and the station
will be stored under the chosen preset. The display will show "Preset 3 stored", for example.
Repeat this procedure as needed for the remaining presets. Alternatively, you can rotate the
Tuning control knob to choose your required preset number and press the Tuning control knob
to confirm your selected preset number. You can also press and hold the Preset button(1-10)
on the remote control to store the station as a preset.
5. Stations which are already stored in the presets may be overwritten by following the above
procedure.

Recalling a preset station

1. Press the Standby/Power button to switch on your radio.
2. Select the required operating mode using the Mode button.
3. Momentarily press the Preset button and then press the required preset number. Your radio
will then tune to the station stored in the selected preset memory. The chosen preset number
is shown in the upper area of the radio display, e.g. 'M3'. Alternatively, you can press the
Preset button and rotate the Tuning control knob to select your required preset number. Then,
press the Tuning control knob to tune to the station stored in the selected preset memory. You
can also press and release the Preset button(1-10) on the remote control to tune to the station
stored in the selected preset memory.
7