Table of Contents
Advertisement
PARTS NAMES
G
H
F
I
1
2
1
ADJ.
LOCK
3
5
English
F
Video output connector (VIDEO OUT: BNC type)
Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector.
G
External sync composite video signal input connector
(VBS IN: BNC type)
Connect to this connector the synchronizing signal output from a synchronizing signal device or the
composite signal of a video distributor.
H
Power indicator (POWER)
Comes on when the power to the camera is on.
I
24 V AC input terminal (24 V AC, GND)
Using a commercially available AC adaptor.
Flange-back adjustment
If the pick-up surface is not correctly positioned with relation to the lens focal point, the picture will be out of
focus (in particular when using auto-iris power zoom lenses, sold separately). If that is the case, adjust the
flange-back position as described below.
1
Using a + screwdriver, loosen the FLANGE BACK LOCK screw (M2:+).
Set the zoom lens to the maximum telephoto position, set the focus using the focus ring on the lens.
2
Set the zoom lens to the maximum wide angle position, set the focus using the FLANGE BACK ADJ.
screw.
3
Repeat steps 2 and 3, until the image stays in focus when changing from a telephoto shot to a wide
angle shot.
When the setting is complete, tighten the FLANGE BACK LOCK screw.
Advertisement
Table of Contents
