•
Remove gasket.
•
Draw conrod off gear wheel and
off pin on blade.
•
Remove screws from gear
housing.
52
•
Remove cutting device.
2
1
•
Unscrew nuts (1).
•
Remove guides (2) and band
spring.
•
Remove sliders.
- Separate blades.
The parts are assembled in rever-
se order.
6
7
•
Place guide (1) on workbench
with screw heads (2) facing
downwards.
•
Slip band spring (3) onto the
screws with the pockets facing
upwards.
•
Secure both blades (4) on the
pockets with cutting edges wor-
king against one another.
•
Place sliders (5) in the pockets
of the band spring.
•
Then add the second guide (6).
•
Screw on new locking nuts (7)
and torque down to 9.5 Nm.
4
1
3
2
•
Pin (1) must engage hole (2) in
conrod.
•
Stub (3) must engage hole (4).
2
4
5
3
2
1