Stihl FS 75 User Manual page 21

Note: The bearing must be pres-
sed in very quickly, as it imme-
diately absorbs heat and begins to
expand.
1 1
•
If the starter side of the crank-
case cannot be heated, press
the deep groove ball bearing in
as far as possible with press
arbor (1) 4119 893 7200.
- Heat area of bearing seat on
clutch side of crankcase to
approx. 120 ° C.
•
Press deep groove ball bearing
into crankcase by hand as far as
possible.
Note: The bearing must be pres-
sed in very quickly, as it imme-
diately absorbs heat and begins to
expand.
1 1
•
If the clutch side of the crank-
case cannot be heated, press
the deep groove ball bearing in
as far as possible with press
arbor (1) 4119 893 7200.
•
Insert the shorter stub of the
crankshaft into the deep groove
ball bearing on the starter side of
the crankcase.
2
•
Completely screw spindle (1) of
assembly tool 5910 890 2202
into sleeve (2) (left-hand thread).
1 1 2 2
•
Screw spindle (1) onto crank-
shaft stub (2) turning clockwise
as far as possible.
1
21