Rack Mounting - D-Link DGS-3610 Series Quick Installation Manual

Warning
Caution

Rack Mounting

You can also mount the switch in the wiring section of a standard 19-inch rack. First fasten the
accessories for rack mounting from the carton onto both sides of the switch and then mount the switch
into the 19-inch rack with screws. When you are doing this, you can use the attached two L-shaped
handle fastening brackets and M3*10FMO sunk screws.
Step
1
Figure 1-2 Schematic Diagram for Installing the L-Shaped Fastening Bracket
Step
2
To prevent overheating of the switch, place the switch in a location where
the ambient temperature is no more than 40° C. Also the spacing of at least
10cm should be reserved around the chassis for good ventilation.
Do not place any heavy objects on the switch.
Keep the fastening brackets with handles closely onto both sides of the
switch, align with the screw holes and fasten them with M3*10FMO sunk
screws, as shown in the following diagram:
Fasten the switch onto the rack, as shown in the following diagram. You
should prepare the screws needed for rack mounting by yourself.