Table of Contents
Advertisement
14.1. VALIDATING STATUS OF A COMPONENT
When using your furnace, you can validate at any time, the status of any of the following components:
•
Distribution blower
•
Air damper
•
Temperature probe (RTD)
•
Hot water system
•
Humidifier
•
Heat pump
14.1.1. DISTRIBUTION BLOWER
To check the status of the distribution blower, go to the main menu under "TROUBLESHOOT LINK" then go to page 5.
When the fan is on, the selected speed is black.
14.1.2. AIR DAMPER, HOT WATER AND HUMIDIFIER
To check the status of the air damper, hot water or humidifier, go to the main menu under "TROUBLESHOOT LINK"
then go to page 3. When the furnace is in wood heating, the damper is open. The green square next to "DAMPER"
should be on the left, (closed circuit). When another heating mode is on, the damper is closed, so the circuit is open
and the green square is on the right. Same logic goes for the hot water and the humidifier.
43
Advertisement
Table of Contents
