Troubleshooting And Error Messages; Troubleshooting - Panasonic KX-WT125 Operating Instructions Manual

Troubleshooting and Error Messages

Troubleshooting and Error Messages

Troubleshooting

Problem Possible Cause
The handset The batteries are drained.
does not work.
The power is off.
The handset Ringer volume is set to
does not ring. " Off" .
Silent Mode is set to " On" ,
or is displayed on the
LCD.
You cannot The handset is out of
make/receive a range, or the CS is busy.
call.
The radio channel is busy,
or a radio communication
error occurred.
You cannot dial. The number that you dialed
is restricted by the PBX.
Key lock mode is on.
The radio channel is busy
or a radio communication
error occurred.
68
Solution
Charge the batteries fully.
(See "Charging the Batteries"
on page 6.)
Re-insert the batteries, and
then set the handset on
the charger. (See "Battery
Installation" on page 5, and
"Charging the Batteries" on
page 6.)
Adjust the ringer volume
level.
(See "Adjusting the Ringer
Volume" on page 15.)
Press for more than 2
seconds to cancel the Silent
Mode.
Move closer to the CS or try
again later.
Try again later.
Consult your dealer.
To cancel the mode, press
for about 2 seconds.
(See "Key Lock" on page 9.)
Try again later.