Panasonic KX-WT125 Operating Instructions Manual page 71

Troubleshooting and Error Messages
Problem Possible Cause
• The CO Status • The software version of
Display is the PBX/CS/card does
displayed as not support this feature.
" ‑" in standby • The " CO Status Display
mode or when in Standby" setting on
receiving the PBX is not enabled.
a call as a • The Single CO line
member of a registered in the " Single
PS ring group. CO Appearance" setting
• During on the PBX is not valid.
operation, the • The " CO Status Disp"
CO Status setting in " Setting
Display is Handset" is set to
not displayed " Off" .
correctly, (See " Display Option"
such as being on page 62.)
displayed as
" ‑" .
In standby
mode, the status
of CO lines is
not displayed on
the soft keys.
Solution
Consult your dealer.
71