Input And Output Jumper Settings - Unitronics V350-35-RA22 Installation Manual

Vision™ OPLC™
I/Os
i4 Automation Ltd - 01480 395256
This model comprises a total of 12 inputs and 8 relays, 2 analog outputs. Input functionality can be
adapted as follows:
1. All 12 inputs may be used as digital inputs. They may be wired in a group via a single jumper
as either npn or pnp.
In addition, according to jumper settings and appropriate wiring:
- Inputs 5 and 6 can function as either digital or analog inputs.
- Input 0 can function as a high-speed counter, as part of a shaft-encoder, or as a normal
digital input.
- Input 1 can function as either a counter reset, normal digital input, or as part of a
shaft-encoder.
- If input 0 is set as a high-speed counter (without reset), input 1 can function
as a normal digital input.
- Inputs 7-8 and 9-10 can function as digital, thermocouple, or PT100 inputs; Input 11 can also
serve as the CM signal for PT100.

Input and Output Jumper Settings

The tables below show how to set a specific jumper to change input functionality. To access the I/O
jumpers, you must open the controller according to the instructions beginning on page 10.
Incompatible jumper settings and wiring connections may seriously damage the controller.
Digital Inputs 0-11: Set Type
Set to JP12 (all Inputs)
npn (sink) A
pnp (source)* B
Inputs 7/8: Set Type - Digital or RTD/TC #1
Set to JP1
Digital* A
Thermocouple B
PT100 B
Inputs 9/10: Set Type - Digital or RTD/TC #0
Set to JP5
Digital* A
Thermocouple B
PT100 B
Input 11: Set Type - Digital or CM for PT100
Set to JP11
Digital* A
CM for PT100 B
Input 5: Set Type - Digital or Analog #3
Set to JP4
Digital* A
Voltage B
Current B
Input 6: Set Type - Digital or Analog #2
Set to JP8
Digital* A
Voltage B
Current B
*Default settings
Unitronics
JP2 JP3
A A
B B
A B
JP6 JP7
A A
B B
A B
JP10
A
A
B
JP9
A
A
B
Analog Output 0: Set to Voltage/Current
Set to JP13
Voltage* A
Current B
Analog Output 1: Set to Voltage/Current
Set to JP14
Voltage* A
Current B
5