Follow the steps below to edit the list of FIPS codes. You can store up to 30 different FIPS
codes in your radio.
Press and hold -
Display the normal menu and choose the Setup sub-menu.
1. Select FIPS Codes. The screen displays any previously-entered FIPS codes.
2. To add a new FIPS code, select New.
increases the number and
4. When the first digit is correct, press
the remaining five digits of the FIPS code in the same way. If you make a mistake while
entering a digit, press
5. When the sixth digit is correct, press
and asks you to confirm. To save this code, select Yes; to cancel this code, select No. The
radio returns to the list of FIPS codes.
6. To change an existing FIPS code, select the code you want to change.
7. To delete the FIPS code, select Delete. To edit the code, select Edit, then use
8. When you are satisfied with the list of FIPS codes, select Exit to close the menu screen.
Changing display and sound options
Your radio display has 10 levels of contrast. To adjust the contrast, press and hold
while the radio is idle. Select System and then Contrast. Use
change the contrast to your desired level.
To restore the default contrast setting, turn the radio off. Press
you turn the radio on.
Your radio has 10 brightness levels on the display. To adjust the brightness, press and hold
while the radio is idle. Select System and then Lamp Adjust. Use
to change the brightness to your desired level.
Key beep is the tone that sounds when you press a key or a button. To turn off the key beep,
Turning the key beep on and off
press and hold
to turn off the key beep.
You will see different display messages on your radio depending on what state your radio is
Setting the GPS position manually
in. Refer to the following table for a description of what displays according to what condition
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
8312 Sidbury Rd.; Wilmington, NC 28411 - (800) 507-0482 / (910) 686-4281
Use the up and down arrows
to adjust each of the six
to change the first of the six digits;
to erase the wrong number and moved the cursor to the
buttons to change each of the six digits.
while the radio is idle. Select System and then Key Beep. Choose Off
digits in turn.
. The cursor moves to the next digit. Enter
. The radio displays the new FIPS code
and hold it in while