Lanier lp145n Hardware Manual page 42

Attaching Memory Unit Type D 128MB, Memory Unit Type E 256MB (SDRAM Module)
Note
❒ Be sure to return the provided screwdriver to its original position on the
inside of the front cover.
❒ After finishing the installation, you can check the memory unit is properly
installed: Print the configuration page from the [List/Test Print] menu. If it is
installed properly, the memory capacity will appear under "Total Memo-
ry" on the configuration page.
❒ The table below shows the total SDRAM module capacities.
Standard
128 MB
128 MB
256 MB
256 MB
❒ If the memory unit is not properly installed, repeat this procedure. If you
cannot install it properly even after reinstallation, contact your sales or
service representative.
❒ Install the controller board carefully to prevent any malfunction.
Reference
For printing the configuration page, see "Printing the Test Page", Quick In-
stallation Guide.
Extended
128 MB
256 MB
128 MB
256 MB
Total
256 MB
384 MB
384 MB
512 MB
2
31