Table of Contents
Advertisement
Short code
EEDF
EEDF
EEDF
EFSM
FAN
FAN
FAN
FAN
FAN
FAN
FAN
FAN
FAN
FBEP
FBET
FOER
HTCO
HTSE
IRER
LAER
LFER
LSER
LTCO
LTSE
MAER
MALE
OPER
PAER
52
Full-text message
EEPROM PAN/TILT
Writing default data to pan/tilt EEPROM based on its CAN address.
EEPROM EFFECT
Writing default data to effect EEPROM based on its CAN address.
EEPROM CMY
Writing default data to CMY EEPROM based on its CAN address.
FAILSAFE MODE
Module error detected during self-check at startup. Service intervention required. Fixture control
possibly disabled, depending on nature of error.
LAMP R FAN ERR
Right-side lamp fan error.
LAMP L FAN ERR
Left-side lamp fan error.
BOTTOM FAN ERR
CMY FAN ERR
TOP FAN ERR
BASE FAN ERR
PU L FAN ERR
Left-side ballast fan error.
PU R FAN ERR
Right-side ballast fan error.
IRIS FAN ERR
PAN FBACK ERROR
Pan feedback error: unable to correct pan position.
TILT FBACK ERROR
Tilt feedback error: unable to correct tilt position.
FOCUS ERROR
Zoom position indexing system error. Fixture will work normally but zoom may lose position and hit
mechanical stop.
HEAD TMP CUT OFF
One or more of the PCB's in the head has reported a temperature above the permitted maximum for
more than 5 minutes. Lamp shut down. A fan may be defective or the ambient temperature may be
too high.
HEAD TMP SEN ERR
A head temperature sensor is not communicating normally. Fans set to full speed.
IRIS ERROR
Iris position indexing system error. Fixture will work normally but iris may lose position and hit
mechanical stop.
LAMP ERROR
Lamp sensing circuit is not detecting light at power on or has detected sudden loss of light. Lamp is
defective or has exploded, is missing, or cannot strike. Pan and tilt are locked. DMX control is
disabled. Fixture cannot be reset by DMX.
LEFT FROST ERROR
Left-side frost position indexing system error. Fixture will work normally but frost filter may lose
position and hit mechanical stop.
LIGHT SENSOR
Light sensor circuit error. Sensor is detecting light but a lamp on command has not been given.
LAMP TMP CUT OFF
A lamp temperature sensor has reported a temperature above the permitted maximum for more
than 5 minutes. Lamp shut down. A fan may be defective or the ambient temperature may be too
high.
LAMP TMP SEN ERR
A lamp temperature sensor is not communicating normally. Fans set to full speed.
MAGENTA ERROR
Magenta position indexing system error. Fixture will work normally but magenta flags may lose
position and hit mechanical stop.
MAINS LOW
Input voltage on electronic ballast is too low. It may be impossible to strike lamp.
ONBOARD PROG ERR
Onboard programming function error.
PAN ERROR
Pan alignment circuit error.
Table 5: Error messages
MAC III Wash user manual
Advertisement
Table of Contents
