Load Paper - Epson WF-2750 Start Here

4
Remove only the yellow tape from each ink cartridge.
Caution: Do not remove any other labels or seals, or ink will leak.
Do not touch the green chip on the cartridge.
5
Insert the cartridge in the holder for each color. Press each
cartridge down until it clicks. Make sure all cartridges are
pushed down into place.
6
Lower the scanner unit.
7
The printer starts charging the ink. Ink charging takes
approximately 4 minutes. When you see a completion
message on the printer's LCD screen, charging is
complete.
Caution: Don't turn off the printer or raise the scanner unit while
the printer is charging or you'll waste ink.
Note:
• The printer is designed for use with Epson
third-party cartridges or ink.
• The cartridges included with the printer are designed for
printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
4

Load paper

1
Make sure the product is done charging the ink, and then
pull out the paper cassette.
cartridges only, not
®
2
Slide the side edge guides all the way out and set the
front edge guide to the paper size you are using.
3
Insert paper with the glossy or printable side down.
Note: Make sure the paper is loaded against the front edge guide
and not sticking out from the end of the cassette.
4
Slide the side edge guides against the paper, but not too
tightly.
5
Keep the cassette fl at as you insert it all the way.
6
Pull out the output tray and its extensions.
7
Select the paper settings on the product's control panel.
For more information on loading different paper types or
envelopes, see the online User's Guide.
LTR