Table of Contents
Advertisement
2
Once the PV-A-300 appliance is physically installed into a rack, you need to connect a
monitor and a USB keyboard, connect the power cord and network cable, and power it on
(see
Figure 1
on page 1-7 and
After the appliance boots and the appliance installation is complete, you must go through
the initial configuration process described in this chapter.
This chapter also includes information on how to change your appliance settings following
your initial configuration, and how to upgrade the Purview application software. For
information on reinstalling the Purview appliance software, see
For information about...
Pre-Configuration Tasks
The following information is needed prior to executing the configuration steps in the next
section:
• Appliance hostname, IP address, and netmask
• Default Gateway IP address
• Name Server IP address and domain name
• NIS (Network Information Services) Server IP address
• GRE tunnel source and destination IP addresses
• Network Time Protocol (NTP) server IP address
In addition, you will need to obtain the appropriate NetSight software license(s) prior to
launching the NetSight applications. You will be prompted to enter a license for any
unlicensed application that is launched. (When you purchased NetSight, you received a
Licensed Product Entitlement ID. This Entitlement ID allows you to generate a product
license. Refer to the instructions included with the Entitlement ID that was sent to you.)
Purview PV-A-300 Appliance Installation Guide
Configuration
Figure 5
on page 1-8).
Chapter
3.
Refer to page...
12
13
19
22
23
12
Hide quick links:
Advertisement
Table of Contents
