Vent-Axia Lo-Carbon iQ Instructions For Use Manual page 19

Lo-Carbon iQ Fan
Disconnect the power supply to the fan – move the safety switch
to position 0 – OFF and then back to position I – ON.
The yellow LED is constantly on
If the fan is connected to an external switch for timer
control, switch this off and wait at least 30 minutes.
Disconnect the power supply to the fan – move the safety switch
to position 0 – OFF and then back to position I – ON.
No LEDs on
This is entirely normal if the fan has been set to
continuous trickle operation. No LEDs are on in this mode.
If the fan has not been set to continuous trickle operation,
disconnect the power supply to the fan – move the safety switch to
position 0 – OFF and then back to position I – ON.
Other faults
The fan stops when the light is switched off.
The fan has been installed incorrectly. Terminal L on the terminal
block should always have direct phase.
Contact your electrician.
The fan stops when the light is switched on.
The fan has probably been programmed to pause
on a momentary switch. See page 11 to deactivate this function
The fan does not work as described remove the cover and
disconnect the power supply to the fan by moving the safety
switch to 0. Then return the switch to I (On).
If the fan still does not work as described in this guide,
contact the retailer or Vent-Axia by sending an e-mail to:
info@vent-axia.com
19 W: www.vent-axia.com/iq