Advertisement
7-9 CHASSIS
Check the disc for wear with a micrometer. Its thickness can be
checked with disc and wheel in place. Replace the disc if the
thickness exceeds the service limit.
Service Limit :
3.0
mm
(0.12
in)
09900-20205:
Micrometer
(0-25
mm)
With the disc mounted on the wheel, check the disc for face
runout with a dial gauge, as shown.
Replace the disc if the runout exceeds the service limit.
Service Limit :
0.3
mm
(0.012
in)
09900-20606 :
Dial gauge
(1/100
mm)
09900-20701 :
Magnetic stand
CALIPER REASSEMBL V
Reassemble and remount the caliper in the reverse order of
removal, and also carry out the following steps:
CAUTION:
Wash the caliper components with fresh brake fluid before
reassembly.
Never use cleaning solvent or gasoline to wash them.
Apply brake fluid to the caliper bore and piston to be insert-
ed into the bore.
• Reassemble and remount the caliper. (Refer to page 7-5.)
WARNING:
Bleed air after reassembling the caliper. (Refer to page
2-12.)
Advertisement
