Table of Contents
Advertisement
3 (fast). Then choose to run the Auto Pan Path in right/left direction from the
Direction drop-down list.
Move the camera to another desired position as the end point of the Auto Pan
Path. Click on the <Set> button of the <End Point> for saving the setting.
Auto Pan Run
Select the specified Auto Pan Path from the drop-down list, click on the <Run>
button, and then the camera will start moving horizontally as recorded.
To view the camera panning in full screen mode, please move the
cursor onto the live view pane, right-click and left-click to select
"fullscreen". Then users can view the camera navigation in full screen.
To stop running an Auto Pan Path, simply move the cursor to the live view pane
and move the camera in any direction.
7.4.4
Sequence
The Sequence Line Programming can be found under this path: PTZ>
Sequence.
The IP Camera supports totally eight Sequence Lines; each Sequence Line
consists of up to 64 Preset Points. Please refer to the instructions below to
program a Sequence Line.
Sequence Setting
Please click on the <Edit> button in <Sequence Setting> section to enter the
NOTE: Before setting this function, users must pre-define at least two
Preset Points.
67
Advertisement
Table of Contents
