LevelOne FCS-4041 User Manual page 45

Triggered Action (Multi-option)
The Administrator can specify alarm actions that will take when motion is
detected. All options are listed as follows:

Enable Alarm Output 1/2
Check the item and select the predefined type of alarm output to enable
alarm relay output when motion is detected.

Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP
and/or E-Mail when motion is detected.

Upload Image by FTP
Select this item and the Administrator can assign a FTP site and
configure various parameters. When motion is detected, event images
will be uploaded to the appointed FTP site.

Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address and
configure various parameters. When motion is detected, event images
will be sent to the appointed e-mail address.
NOTE: Make sure SMTP or FTP configuration has been
completed. Refer to Mail and FTP for further details.

Send HTTP notification
Check this item, select the destination HTTP address, and specify the
parameters for event notifications by <Motion Detection>
When an alarm is triggered, the notification can be sent to the specified
HTTP server
For instance, if the custom parameter is set as" action=1&group=2", and
the HTTP server name is" http://192.168.0.1/admin.php", the notification
will be sent to HTTP server as"
action=1&group=2" when alarm is triggered.
 Record stream to SD Card
Select this item and the Motion Detection recording will be stored in
Micro SD/ SDHC card when motion is detected.
NOTE: Please make sure the local recording (with Micro SD/
SDHC card) is activated so that this function can be
implemented. Refer to
http://192.168.0.1/admin.php?
Recording for further details.
45
triggered.