What To Expect When Treating With Silk'n Flash&Go; After Treating With Silk'n Flash&Go - Silk'n Flash&GO Quick Start Manual

Try to avoid overlapping pulses!
Do not treat the same area of skin more than once per hair removal session!
If your skin blisters or burns, STOP USE IMMEDIATELY!
10.3. What to Expect when treating with Silk'n Flash&Go™?
For many people, using Silk'n Flash&Go™ may be their first experience with a light-based device designed
for home use. Silk'n Flash&Go™ is simple to use, and hair removal sessions go by quickly. During a Silk'n
Flash&Go™ session it is normal to experience and feel:
A Fan Noise – The cooling fan in Silk'n Flash&Go™ makes noise similar to a hairdryer. This is normal.
A Pop Sound with Each Pulse – When a pulse of HPL™ light is activated, it is normal to hear a subtle pop
sound simultaneously with the flash of light.
Moderate Pressure of the Treatment Surface – This is necessary and helpful for placement of adjacent
pulses of light, and is part of the unique safety feature of Silk'n Flash&Go™.
A Sensation of Warmth and Tingling – During each pulse of light it is normal to feel a mild sensation of
warmth and tingling from the light energy.
Remember it is important to always use low energy settings for initial hair removal sessions. You may feel
some warmth for up to an hour after your Silk'n Flash&Go™ session.
Some Mild Red or Pink Color – During and just after your Silk'n Flash&Go™ session it is not uncommon
to see some very mild, pink-like color of the skin. This is usually most noticeable around the hairs
themselves.
However if you see full redness of the skin, blistering or burns stop use of Silk'n Flash&Go™ immediately.
10.4. After treating with Silk'n Flash&Go™
When Silk'n Flash&Go™ session has been completed turn Silk'n Flash&Go™ off by pressing the On/Stby
Switch. All the lit indicators will turn off and the Stby Indicator Light will turn on (Be sure to remember the last
energy level setting you used, as it will not be restored when turning Silk'n Flash&Go™ on again.)
Unplug the Adaptor cord from the electrical outlet.
After each hair removal session it is recommended that you clean your Silk'n™ Flash&Go device, especially the
Treatment Surface (See: "Cleaning Silk'n Flash&Go™").
After cleaning, it is recommended to store your Silk'n Flash&Go™ device in its original box, and keep it away
from water.
14