Silk'n Flash&GO Quick Start Manual page 13

If your skin blisters or burns, STOP USE IMMEDIATELY!
Energy Level
Energy level determines the intensity of the Silk'n Flash&Go™ light pulse delivered to your skin, from the
lowest level (-) to the highest level (+). Corresponding Indicator Lights on the Control Panel represent
the increase in energy. As energy level increases, so does hair removal results as well as the risk of possible
side effects and complications.
Always start your first Silk'n Flash&Go™ hair removal session at the lowest energy setting.
If you experience little or no discomfort during and after the hair removal session using the lowest
energy level, raise the energy level by one Indicator Light at the next session, and so on for each
subsequent session.
Do not raise the energy level if you experience abnormal discomfort during or after treating
with Silk'n Flash&Go™! (See "Possible Side Effects")
Do not raise the energy level during hair removal session even if you experience no
discomfort. Discomfort may also appear some time after the session.
Note! After replacing the disposable lamp cartridge with a new one, always set the energy to be one
level lower than your normal setting. Raise the energy level back, only if you do not experience abnormal
discomfort during or after the treatment
Whenever Silk'n Flash&Go™ is turned on its energy level will automatically be reset to the lowest energy
level. Only one Energy Level Indicator Light will be on.
To set the energy level, press the Energy Level Setting Buttons using "-" or "+" to respectively decrease
or increase the energy level. The number of Energy Level Indicator Lights will coincide with the change
in energy level.
The Skin Color Sensor
Light-based hair removal on darker skin tones can result in adverse effects such as burns, blisters, and skin
color changes (hyper- or hypo-pigmentation).
To prevent such misuse, a unique Skin Color Sensor in Silk'n Flash&Go™ measures the treated skin
complexion at the beginning of each session and occasionally during the session. If the Skin Color Sensor
detects a skin tone that is too dark for Silk'n Flash&Go™ application, the device will automatically stop
emitting pulses.
If you see no light pulse and the Skin Tone Warning Indicator Light blinks, this is an indication that your skin
tone, measured by the Skin Color Sensor, is too dark for safe application. Try using the device on a different
body part or contact the Silk'n Flash&Go™ support.
Covering skin areas
Silk'n Flash&Go™ pulses should be administered in rows, starting at one end of each row and progressing
sequentially towards the other end. This technique allows better control of skin coverage, and helps you avoid
treating the same area more than once or overlapping skin areas.
When applied to the skin, the Silk'n Flash&Go™ Treatment Surface is designed to create temporary pressure
marks on the treated area. These visible marks can be used for proper positioning of the next pulse.
13