First Steps With Silk'n Flash&Go; Silk'n Flash&Go Setup; Treating With Silk'n Flash&Go™ For The First Time - Silk'n Flash&GO Quick Start Manual

10. First steps with Silk'n Flash&Go™
10.1. Silk'n Flash&Go™ Setup
1. Remove Silk'n Flash&Go™ Hair Removal Unit and other components from box.
2. Verify that the Disposable Lamp Cartridge is inserted properly at the tip of the device.
3. Plug the Adaptor cord into the Silk'n Flash&Go™ Hair Removal Unit socket.
4. Plug the Adaptor into an electrical outlet. The Stand By Indicator Light will turn on.
Your Silk'n Flash&Go™ is now ready to start.
10.2. Treating with Silk'n™ Flash&Go for the first time
The skin should be shaved, clean, dry and free of any powders, antiperspirants or deodorants.
5. Press the On/Stby Switch. The Power On Indicator Light will turn on and a fan sound (similar to the sound
of a hairdryer) will start.
6. Approximately 3.5 seconds after pressing the On/Stby Switch, the Ready Indicator Light will turn on. The
device sets itself to deliver the lowest energy level pulses. The device is then ready for you to trigger the
first pulse.
7. If the energy level should be higher than the lowest, press the Energy Level Setting Buttons using the "-"
or "+" to respectively decrease or increase the energy level, until the desired energy level is set. Energy Level
Indicator Lights will coincide with the energy level setting. (See "Energy Level" frame).
8. Apply the Treatment Surface firmly to the skin, making sure the skin is spread evenly and smoothly. As soon
as the Treatment Surface is in full contact with the skin, the Ready Indicator Light will start blinking.
9. Press the Pulse Button. The device will first determine the color of your skin.
If the color of the skin is light enough for safe application, the device will flash a pulse of light onto your skin,
and the Ready Indicator Light will turn off.
You will see a bright flash of light and simultaneously hear a subtle pop sound, which is a normal noise for the
device. You may feel a mild sensation of warmth and tingling.
Silk'n Flash&Go™ will immediately recharge for the next pulse. After 3.5 seconds the Ready Indicator Light
will turn on again.
If you see no light pulse and the Skin Tone Warning Indicator Light blinks your skin tone, measured by the
Skin Color Sensor, is too dark for safe application. Try using the device on a different body part or contact the
Silk'n™ support (See: "The Skin Color Sensor" frame)
10. Remove the Treatment Surface from the treated area of skin.
11. Move the Treatment Surface to another area of skin. Use the pressure marks the device just made on your
skin to guide you for proper positioning of the next pulse, avoiding both gaps and overlaps between pulses
(See "Covering skin areas" frame).
Warning: Do not treat the same area of skin more than once per hair removal session! Treating the same area
of skin more than once per session increases the likelihood of adverse effects.
12. Repeat the process starting again with Step 5.
12