Connect Choke Cable; Connect Wire Harness - Toro ProLine 30180 Operator's Manual

Connect Choke Cable

1. Route choke cable around right side of engine
(Fig. 5).
2. Move remote choke control into full choke
position.
3. Hook cable Z-bend into hole in carburetor choke
lever (Fig. 7).
4. Loosen cable clamping screw allowing cable
installation, but do not tighten (Fig. 7).
5. Pull firmly on choke cable and tighten cable
clamp screw (Fig. 7).
6. Secure choke and throttle cables to right side of
engine with cable clamp and engine cover
mounting bolt (Fig. 5).
2137
Figure 7
1. Choke cable
2. Choke lever

Connect Wire Harness

1. Route harness around left side of engine and
plug into connector at front of engine (Fig. 7).
2. At left side of engine, secure clutch connectors
(Fig. 8).
3. Cable clamp screw
4. Connectors
3. Remove lock nut from left rear engine mounting
bolt. Secure negative, black, battery cable and
ring terminal wire from clutch connector to left
rear engine mounting bolt. Secure with lock nut
removed (Fig. 8).
4. Secure remaining gray ring terminal wire from
wire harness and positive, red battery cable to
rear terminal of starter solenoid with a 1/4–20
lock nut (Fig. 8).
5. Push yellow and black wire terminals onto spade
terminals on starter solenoid.
Figure 8
1. Clutch wire connector
2. Starter solenoid
3. Ring terminal wire
4. Negative battery cable
5. Engine mounting bolt
6. Secure wire harness to fuel line with cable tie
(Fig. 9).
Figure 9
1. Cable tie
Set-Up
2138
6. Gray wire
7. Positive battery cable
8. Black wire
9. Yellow wire
2139
15