Table of Contents
Advertisement
Maintenance
Replacing the Traction Belt
1.
Raise the front of the machine and hold with
jack stands. Remove lower shield (4) bolts.
2.
Disconnect in–line wire connector from wire
harness to electric clutch.
3.
Remove left front engine mounting bolt securing
clutch retainer to frame (Fig. 36). Unhook
retainer from clutch and remove retainer.
4.
Unhook tension spring from side of frame
(Fig. 36).
5.
Loosen pivot bolt enough to remove traction belt
from the drive pulley and clutch.
6.
Install new belt around clutch and drive pulley.
7.
Torque pivot bolt to 47-54 N.m (35-40 ft. lb.)
Install tension spring between idler arm and
frame bracket (Fig. 36).
8.
Hook clutch retainer into clutch and secure to
frame with engine mounting bolt. Torque engine
mounting bolt to 19-24 N.m (170-220 in. lb.)
9.
Connect clutch in–line wire connector to wire
harness.
10. Install lower shield.
4
6
3
Figure 36
1. Lower shield
2. Traction belt
3. Idler pulley
4. Clutch retainer
34
2
5
1
7
2148
5. Tension spring
6. Adjusting nut
7. Pivot bolt
Adjusting the Electric Clutch
The clutch is adjustable to ensure proper engagement
and proper braking
1.
To adjust clutch, tighten or loosen adjusting nuts
(Fig. 36).
2.
Check adjustment by inserting feeler gauge thru
slots next to studs.
3.
The proper disengaged clearance between the
clutch plates is 0.30-0.45 mm (.012–.018 in.). It
will be necessary to check this clearance at each
of the three slots to ensure the plates are parallel
to each other.
Hide quick links:
Advertisement
Table of Contents
