Connecting The Throttle Cable; Connecting The Choke Cable; Installing The Shift Lever - Toro 30150 Operator's Manual

Connecting the Throttle Cable

1. Hook the throttle cable inner wire into the hole of the
speed control lever (Fig. 9).
2. Move the throttle control lever to the Fast position
(Fig. 9).
3. Loosen the throttle cable clamp screw (Fig. 9).
4. Pull the throttle cable slightly to remove any slack in
the inner wire (Fig. 9).
5. Tighten the cable clamp screw to lock the adjustment in
place (Fig. 9).
6. Move the throttle lever to make sure the carburetor
valve moves.
6
Figure 9
1. Throttle cable
2. Throttle cable inner wire
3. Speed control lever
4. Cable clamp screw

Connecting the Choke Cable

1. Move the choke control to the Open position (Fig. 9).
2. Hook the choke cable inner wire into the hole of the
choke control lever (Fig. 9).
3. Loosen the choke cable clamp screw (Fig. 9).
4. Pull the choke cable slightly to remove any slack in the
inner wire (Fig. 9).
5. Tighten the cable clamp screw to lock the adjustment in
place (Fig. 9).
6. Move the choke control to make sure the carburetor
choke valve moves.
7
4 5
1
4
2
3
m–7537
5. Choke cable
6. Choke control lever
7. Choke cable inner wire
16

Installing the Shift Lever

1. Remove the locknut (3/8 inch) and spring washer from
the stud on top of the transmission (Fig. 10).
Note: Do not remove rubber seal washer and square hole
washer from transmission shaft.
2. Slide the shift lever through the control panel and align
the mounting hole in lever with square on transmission
shaft (Fig. 10).
3. Secure lever to transmission with previously removed
spring washer and locknut (Fig. 10).
4. Replace the spring washer, dish down, and locknut
(Fig. 10).
5. Torque the nut to 35 ft–lb (47 N m).
Figure 10
1. Shift lever
2. Control panel
3. Rubber seal washer
Adjusting the Shift Lever Plate
1. Shift lever to second gear and check alignment of lever
in slot of shifter lever plate. The clearance between top
and bottom of the shift lever should be equal (Fig. 11).
2. If clearance is not correct, remove lever and bend it
slightly to adjust (Fig. 11).
Note: Do not bend lever while attached to transmission
shaft or damage may occur.
3. Shift lever to neutral and check alignment of lever in
slot of shifter lever plate. The clearance on the sides of
shift lever should be equal (Fig. 11).
m–3772
4. Square hole washer
5. Spring washer
6. Locknut 3/8