Install The Battery - Toro ProLine 30180 Operator's Manual

Install the Battery

1. Mount battery holders to left rear corner or
cutting unit carrier frame with (2) 3/8–16 x
1–3/4" bolts and lock nuts.
2. Peel off backing from battery pads and affix pads
to battery holder, positioning as shown (Fig. 13).
1
Figure 13
1. Battery holder
IMPORTANT: Activate battery with
electrolyte and charge before installing.
3. Position battery onto holder with terminal posts
toward engine (Fig. 14).
4. Slide the red terminal boot onto the red battery
cable and the black terminal boot onto the the
black battery cable (Fig. 14).
5. Install the positive battery cable to positive (+)
battery terminal and the negative battery cable to
the negative (–) battery terminal and secure with
carriage bolts and lock nuts.
6. Mount battery to holders with (2) support rods,
battery clamp and (2) lock nuts. Position support
rods in mounting holes as shown in (Fig. 14).
Tighten lock nuts so battery is held securely in
position and will not slide.
Note: DO NOT OVERTIGHTEN.
2
2145
2. Battery pad
3
4
1
6
2146
Figure 14
1. Battery holder
2. Battery pad
3. Battery terminal boot
4. Negative battery cable
Set-Up
7
5
6
2
5. Positive battery cable
6. Battery support rod
7. Battery clamp
17