Makita UR140D Instruction Manual page 11

012408
012409
To remove the Nylon cutting head (spool and spool
cover) from the string trimmer, press in the latches
forcefully on both sides of the spool cover and raise it.
1
2
012440
NOTICE:
Make sure that the spring is installed inside the
•
spool holder.
To install a cord-newly-wound Nylon cutting head (spool
and spool cover) on the string trimmer, align the Nylon
cord eyehole with the notch of the Nylon cutting head
installation port on the trimmer and then press in it until
a click is heard.
Winding a new Nylon cord on the spool
012412
Remove the spool from the spool cover and take off the
remaining used Nylon cord from the spool.
1. Nylon cord
eyehole
2. Notch of the
nylon cutting
head installation
port
3
3. Spring
4. Spool holder
4
1
012413
Insert a Nylon cord to the retainer shown in the figure.
012414
Wind it tightly flat around the spool in the direction of
arrow on the spool so that the wound Nylon cord
surface appears uniform over the winding area.
012415
Temporarily fix a Nylon cord at the notch shown in the
figure.
012416
Bring the Nylon cord through the Nylon cord eyehole in
the spool cover.
11
1. Nylon cord
2. Retainer for
nylon cord end
2