Initial Software Configuration - Sun Microsystems fire V20Z Installation Manual

Hide thumbs Also See for fire V20Z:

Table of Contents

C H A P T E R

Initial Software Configuration

To set up your Sun Fire V20z or Sun Fire V40z server the first time, you should

perform some initial configuration tasks. This chapter explains these initial steps:

"Configuring the Service Processor" on page 22

■

"Installing and Mounting the NSV Software" on page 31

■

"Setting up the Platform Operating System and Drivers" on page 33

■

Note – An operating system can be installed on the server without configuring the

service processor (SP) or the network share volume (NSV). However, if you choose

to skip the SP and NSV setup, you will not be able to use the remote-management

capabilities of the system or the diagnostics.

"Defining SP Network Settings" on page 22

"Defining a Name for the Server" on page 28

"Creating the Initial Manager Account" on page 26

(optional)

Table of Contents

Do you have a question about the fire V20Z and is the answer not in the manual?

Fire v40z