Pattern (Menu => Function => Pattern Or Shortcut: Ptrn); Shortcut Of Preset Program - Honeywell ScanDome iii HSDC-251N/P Operation & Programming Manual

Follow the steps below to program the Preset positions.
1. Select the camera number by pressing 0 ~9 and CAM.
2. Simply press PRST button to enter preset menu. ( MENU => FUNCTION => PRESET)
3. Select the empty preset location to be programmed using the Joystick up/down. If
selected location is not empty, pressing PRST button will show your predefined position.
4. After selecting an empty position, press and hold SHFT/PGM then use the Joystick to
control the direction of the camera and lens.(Or twist zoom handle or hit zoom button to
start PTZ control for view selection.)
5. After aiming the camera (view direction and lens control) at specific position, release
SHFT/PGM button(or hit the focus button). The selected location No. field will be filled with
"A A F". Push the joystick to the right to select each Focus/ Iris /BLC mode using zoom
handle.
6. Move the cursor to the title field to edit/enter the title. Rotate the handle CW and CCW or
press Tele or Wide button to scroll through the alphanumeric characters. Push the
handle to right or left to select next or previous digit.
7. To finish entering the title, push the Joystick up/downward.
8. Locate the cursor on "PREV NEXT" item to select the previous/next page of presets,
scroll the page by pushing the Joystick to the Left on "PREV
9. Repeat steps 2 through 8 for each additional preset position.
10. Select Save and Exit by pushing the Joystick to the right. Press ESC to exit the Preset
menu without saving.
NOTE: Press the Home or OFF button at programmed position to delete a programmed preset view.

Shortcut of Preset Program.

Select direction of the camera, zoom and focus to be programmed, then press No. (1~248), and
then press SHFT, PRST subsequently. The current view will be stored to the selected preset
number if position is empty. If selected preset number is not empty, "PRESET EXISTING"
message will be displayed on the monitor and you will be prompted to overwrite.
Example: 1, 0 + PGM + PRST will memorize current view as preset No. 10. In this case, focus
and Iris mode will be memorized as auto and dwell time will be set to 3 sec.
3.1.3 PATTERN (
The Pattern function stores user's control of the selected dome camera for up to 240 seconds. 4
patterns can be stored in 240 seconds of total recording space. Stored pattern is played back by
pressing No.+ PTRN buttons subsequently.
MENU => FUNCTION => PATTERN or Shortcut
19
NEXT".
: PTRN)