Gree GMV-PD100W/NAB-K Service Manual page 122

DC Inverter Multi
VRF Service Manual
Removal and Installation of Compressor
Remark: Before removing the compressor, make sure that there is no refrigerant
inside the pipe system and that the power has been cut off.
Step
1. Remove the power cord
compressor onto foundation.
compressor onto foundation.
4. Remove the compressor
from chassis
118
Illustration
Mark the power
cable colors and
corresponding
terminal codes
during removal.
Heat by welding
and pull the
exhaust /
suction pipe out.
Use spanner to remove the
Handling Instruction
Note: When removing the
power cable, please mark
the power cable color and
corresponding terminal, thus to
avoid error during reinstallation.
of compressor by welding;
Note: During welding, take care not
onto the base seat
and replace it
Note: When replacing the
compressor, take care not to touch
the pipes and components beside.