Table of Contents
Advertisement
Engine Oil
Check the engine oil level each time the mower is used or
after every 5 operating hours. Change the oil after the first
20 operating hours and every 50 hours thereafter. More
frequent oil changes are required in dusty or dirty
conditions.
Checking the Oil Level
1. Position mower so the engine is level and clean around
oil level gauge (Fig. 29).
Figure 29
1. Oil level gauge
2. Remove oil level gauge by rotating it
counterclockwise.
3. Wipe oil level gauge clean and insert it into filler port.
Do not screw into port. Then remove and check level
of oil. If level is low, add only enough oil to raise level
to bottom of filler opening. Recheck level of oil. Do
not overfill.
4. Reinstall oil level gauge and wipe up any spilled oil.
Changing the Oil
1. Start and run engine for a few minutes to warm the
engine oil.
2. Place a drain pan at rear of machine under drain plug
(Fig. 29). Remove drain plug.
2. Drain plug
24
3. Push down on handle to tip mower and engine
backward, allowing more oil to run into drain pan.
4. Install drain plug and refill crankcase with proper oil;
refer to Checking the Oil Level, page 24.
Servicing the Air Cleaner
Normally, clean air cleaner after every 25 operating hours.
More frequent cleaning is required when mower is
operated in dusty or dirty conditions.
1. Make sure wire is off spark plug.
2. Remove wing nuts securing air cleaner cover to air
cleaner and remove cover. Clean cover thoroughly
(Fig. 30).
Figure 30
1. Air cleaner cover
3. If foam element is dirty, remove it from paper element
(Fig. 31). Clean thoroughly.
A. Wash foam element in a solution of liquid soap and
warm water. Squeeze to remove dirt, but do not
twist because foam may tear.
B. Dry by wrapping in a clean rag. Squeeze rag and
foam element to dry.
C. Saturate element with clean engine oil. Squeeze
element to remove excess oil and to distribute oil
thoroughly. An oil damp element is desirable.
Advertisement
Table of Contents
