Specifications; General Specifications - Toro 04021 Operator's Manual

Specifications

General Specifications

Engine
Fuel capacity
Traction/implement drive
Ground speed
Traction drum
Controls
Handle
Optional Transport tires
Reel construction
Suspension
Width of cut
Height of cut
Clip frequency
Bedknife/bedbar
Grass basket
Rollers
Dry weight
Kawasaki, 4-cycle, 3.7 (2.7 kw) air cooled OHV engine, 3600 RPM, 7.57 cu in.
(124 cc) displacement, cast iron cylinder sleeve; electronic ignition with integral
lighting coil; maximum noise suppression muffler; 83 dB(A) at operator's ear
2.64 qt. (2.5 l); regular grade unleaded gasoline
Integral gearbox assembly directly mounted to the engine. The traction drive
consists of a constant mesh planetary gear reduction incorporating a wet bath
band-type clutch and brake driving a Peerless differential assembly integrated into
the gearbox assembly. The implement drive is a constant mesh gear driven
countershaft with integral cone wet clutch.
Mowing speed: 1.3 to 3.5 MPH (2.1 to 5.6 km/h)
Transport speed: 5.3 MPH (8.5 km/h) maximum
Dual cast aluminum, 7.5 in. (19 cm) diameter tapered on outer 1/3 of length
Engine mounted on/off switch, recoil starter, and choke; handle mounted throttle
lever, dual function traction/reel control lever, service/parking brake lever; safety
devices include neutral interlock system, service/parking brake, enclosed
Loop style; 1 in. (2.5 cm) diameter with easy pull pin height adjustment, operator
selected
Two quick detachable pneumatic tires; 3.00/3.25 x 6, 3.25 in. (8.25 cm) tread width;
15 psi (1.03 bars) tire pressure
5 in. (12.7 cm) diameter, 11 high strength, low allow steel blades, through
hardened, impact resistant
Semi-floating cutting unit separable from drive unit pivoting around reel centerline
(pitch axis) and pivoting around bedknife centerline side to side (roll axis)
21 in. (53.3 cm)
1/16 to 19/64 in. (1.5 to 7.5 mm) with Micro–Cut bedknife
11 blade (standard): .16 in. (4.1 mm)
11 blade w/clip kit: .14 or .21 in. (3.5 or 6.4 mm)
Dual screw adjustment to reel; bedknife is high carbon through-hardened steel;
micro–cut bedknife standard
Molded polyethylene with integrated graphics highlighting overlap guidelines;
vented for high efficiency collection
Front roller: aluminum Wiehle, 2.5 in. (6.35 cm) diameter, .20 spacing, with sealed
bearings and multi-lip seals standard
Rear roller: aluminum full roller, 2 in. (5.1 cm) diameter with sealed bearings and
multi-lip seals standard
250 lb. (114 kg) with aluminum Wiehle roller, kickstand and grass basket; without
transport tires and groomer
9