Maintenance And Storage - Toro 04021 Operator's Manual

Watch out for traffic when crossing or near roadways.
Stop the blades rotating before crossing surfaces other
than grass.
When using any attachments, never direct discharge of
material toward bystanders nor allow anyone near the
machine while in operation.
Never operate the machine with damaged guards,
shields, or without safety protective devices in place.
Be sure all interlocks are attached, adjusted properly,
and functioning properly.
Do not change the engine governor settings or
overspeed the engine. Operating the engine at
excessive speed may increase the hazard of personal
injury.
Before leaving the operator's position:
– stop on level ground;
– disengage the power take-off and lower the
attachments;
– change into neutral and set the parking brake;
– stop the engine.
Disengage drive to attachments when transporting or
not in use.
Stop the engine and disengage drive to attachment
– before refuelling;
– before removing the grass catcher/catchers;
– before making height adjustment unless adjustment
can be made from the operator's position.
– before clearing blockages;
– before checking, cleaning or working on the
mower;
– after striking a foreign object or if an abnormal
vibration occurs. Inspect the mower for damage
and make repairs before restarting and operating
the equipment.
Reduce the throttle setting during engine run-out and,
if the engine is provided with a shut-off valve, turn the
fuel off at the conclusion of mowing.
Keep hands and feet away from the cutting unit.
Slow down and use caution when making turns and
crossing roads and sidewalks. Stop reels if not
mowing.
Do not operate the mower under the influence of
alcohol or drugs
Use care when loading or unloading the machine into a
trailer or truck
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure vision.

Maintenance and Storage

Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
Never store the equipment with fuel in the tank inside
a building where fumes may reach an open flame or
spark.
Allow the engine to cool before storing in any
enclosure.
To reduce the fire hazard, keep the engine, silencer,
battery compartment and fuel storage area free of
grass, leaves, or excessive grease.
Check the grass catcher frequently for wear or
deterioration.
Keep all parts in good working condition and all
hardware and hydraulic fittings tightened. Replace all
worn or damaged parts and decals.
If the fuel tank has to be drained, do this outdoors.
Be careful during adjustment of the machine to
prevent entrapment of the fingers between moving
blades and fixed parts of the machine.
Disengage drives, disengage the cutting unit, set
parking brake, stop engine and disconnect spark plug
wire. Wait for all movement to stop before adjusting,
cleaning or repairing.
Clean grass and debris from cutting unit, drives,
mufflers, and engine to help prevent fires. Clean up oil
or fuel spillage.
Carefully release pressure from components with
stored energy.
Disconnect battery and remove spark plug wire before
making any repairs. Disconnect the negative terminal
first and the positive last. Reconnect positive first and
negative last.
Use care when checking the reel. Wear gloves and use
caution when servicing them.
Keep hands and feet away from moving parts. If
possible, do not make adjustments with the engine
running.
5