Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts Chart
Note: Use this chart as a checklist to ensure all parts necessary for assembly have been shipped. If any of these parts are
missing, total setup cannot be completed.
Description
Grass basket
Operator's manual
Engine operator's manual
Parts catalog
Operator video
Certificate of compliance
Registration cards
Installing the Handle
1. Remove the flange lock nut from the capscrew and
pivot pin on each side of the mower (Fig. 3).
Figure 3
1. Flange lock nut
2. Insert the handle ends through the slots in the handle
support arms (Fig. 4).
3. Squeeze the handle ends inward and install them on
the step of the pivot pin (Fig. 4).
Qty.
2. Pivot pin
11
Use
1
Install on the machine.
1
Read before operating the machine.
1
Read before operating the machine.
1
1
View before operating the machine
1
2
Fill out and return to Toro.
Figure 4
1. Left handle end
2. Support arm
4. Secure the handle to the capscrew and pivot pin with
the flange lock nut (Fig. 4).
5. Locate cable tie loosely securing throttle cable to wire
harness. Position cable tie approximately one inch
behind transmission and tighten cable tie.
3. Pivot pin
4. Locknut