Figure 51
1. Positive Battery Post
2. Negative Battery Post
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short.
Fuse: Main/Ignition -20 amp, blade-type
Glow plug/Alternator -40 amp, blade-type
1. To gain access to the main fuse, unlatch the seat
and tilt the seat forward. To gain access to the fan
and alternator fuses, raise the seat and tilt the engine
cover forward.
2. To replace a fuse, pull out on the fuse to remove it
(Figure 52).
Figure 52
1. Glow plug/Alternator-
40 amp
3. Red (+) Charger Lead
4. Black (-) Charger Lead
2. Main/Ignition-20 amp
Drive System
Maintenance
Adjusting the Tracking
The machine has a knob for adjusting the tracking
located under the seat.
Important: Adjust the handle neutral and hydraulic
pump neutral before adjusting the tracking. Refer
to Adjusting the Handle Neutral in Controls System
Maintenance , page 47 and Adjusting the Hydraulic
Pump Neutral in Hydraulic System Maintenance ,
page 48.
1. Push both control levers forward the same distance.
2. Check if the machine pulls to one side. If it does,
stop the machine and set the parking brake.
3. Unlatch the seat and tilt the seat forward to access
the tracking knob.
Note: Determine the left and right sides of the
machine from the normal operating position.
4. To make the machine go right, turn the knob towards
the rightside of the machine. Refer to Figure 53.
5. To make the machine go left, turn the knob towards
the leftside of the machine. Refer to Figure 53.
6. Repeat adjustment until the tracking is correct.
1. Tracking knob
2. Hydraulic tank
3. Hydraulic pumps
39
Figure 53
4. Turn this way to track right
5. Turn this way to track left