Table of Contents
Advertisement
Figure 10
Continuous Audible Alarm
The continuous audible alarm alerts the user that the
engine is over heating. Refer to Servicing the Cooling
System.
Pulsing Audible Alarm
The pulsing audible alarm alerts the user to low oil
pressure or the alternator is not charging. Refer to
Checking the Engine Oil and check the alternator belt.
Operating the Parking Brake
Always set the parking brake when you stop the
machine or leave it unattended.
Setting the Parking Brake
1. Move the motion control levers (Figure 16) out to
the neutral lock position.
2. Pull up and back on the parking brake lever to set
the parking brake (Figure 11). The parking brake
lever should stay firmly in the engaged position.
Parking brake may not hold machine parked
on a slope and could cause personal injury or
property damage.
Do not park on slopes unless wheels are
chocked or blocked
Releasing the Parking Brake
Push forward and down on the parking brake lever
to release the parking brake (Figure 11). The parking
brake is disengaged and the lever will rest against the
brake stop.
1. Parking brake-ON
2. Parking brake-OFF
Starting and Stopping the
Engine
Starting the Engine in Normal Weather
1. Raise the ROPS up and lock into place, sit on the
seat and fasten the seat belt.
2. Move the motion controls to the neutral locked
position.
3. Set the parking brake; refer to Setting the Parking
Brake.
4. Move the PTO (power take off) switch to the off
position (Figure 12).
5. Move the throttle lever to the middle position
(Figure 12).
6. Turn the ignition key clockwise to the run position
(Figure 12). The glow plug light will turn on.
7. After the glow plug indicator light goes out, turn
the key to the start position. when the engines starts
release the key.
18
Figure 11
3. Brake Stop
Advertisement
Table of Contents
