Baudrate Settings; Protocol Settings; Communication Mode Settings - HIKVISION e series Installation Manual

E Series IR Speed Dome Installation Manual

1.3.2 Baudrate Settings

The No. 1, 2 and 3 of SW2 switch are for setting the baudrate of the speed dome, standing for
2400bps, 4800bps and 9600bps respectively. The baudrate will be set as 2400bps by default if it is
out of this range. Refer to the following table:

1.3.3 Protocol Settings

The No. 4, 5 and 6 of SW2 switch are for setting the communication protocols of the dome. Refer to
the following table:
Notes:
 The speed dome is self-adaptive to PELCO-D, PELCO-P and private protocol which cannot set by
the DIP switches.
 Network speed dome model does not support Manchester Code protocol.

1.3.4 Communication Mode Settings

The No. 7 of SW2 switch is for setting the RS485 communication mode of the dome to simplex or
half-duplex.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Table 1-3 Set the Baudrate of the Dome
DIP Switch SW2-Baudrate Settings
Baudrate Figure
ON
2400
SW2
1 2
ON
4800
SW2
1 2
ON
9600
SW2
1 2
Table 1-4 Set the Protocol of the Dome
DIP Switch SW2-Protocol Settings
Protocol
SW
AD Manchester
2
Others
Table 1-5 Set Communication Mode of the Dome
DIP Switch SW2-Simplex/Half-duplex
Description
Simplex
Half-duplex
1
ON OFF
3 4 5 6 7 8
OFF ON
3 4 5 6 7 8
ON ON
3 4 5 6 7 8
Figure 4
O
N
ON
1 2 3 4 5 6 7 8
Self-adaptive
Settings
Figure
ON
OFF
SW2
1 2 3 4 5 6 7 8
ON
ON
SW2
1 2 3 4 5 6 7 8
2 3
OFF
OFF
OFF
5 6
ON ON
7
12